ANDRITZ Gouda contact drum dryer
For more than a century, food products have been dried industrially. Since its early years ANDRITZ Gouda has been specialized in food processing lines, based on advanced drum drying technology. Nowadays it is used for a large range of products, from baby food to chemicals.
- high thermal efficiency
- ultimate stability and a long, continuous lifecycle
- designed in accordance with the highest hygienic standards
- several versions to fullfil the requirements of different applications
- vacuum drying for heat sensitive product components
|Animal-based glue, pesticides, sodium benzoate,
polymers, pigments, detergents, enzymes, proteins
|Cereal-based baby food, milk, cereal-based drinks,
yeast, pre-gelatinized starch, gelatin, potatoes, fruit
The ANDRITZ Gouda drum dryer with its continuous indirect drying method, allows short heat retention times while evaporating all the liquid within a single rotation of the drum. It not only virtually eliminates the risk of damaging the product but also enables the product to keep its unique properties like taste, smell, texture, etc.
The drum drying process
The drum body of the drum dryer is heated on the inside by steam. A special composition of cast iron gives the drier a combination of favourable properties: accurate shape retention even at high steam pressure and temperature, and excellent "scraping properties" for the scraping knife.
Steam heating gives a uniform temperature distribution over the drum surface and this results in a consistent product quality. The steam condenses on the inside of the drying drum. The condensate is continuously removed from the drum, so that the largest possible surface area remains available on the inside of the drum for condensation of the steam. The steam system is a closed system, which means that the product cannot come into contact with the steam or condensate.
Depending on the design of the drum dryer, the product is applied continuously as a thin film on the underside or top of the main drum. As the drum rotates and is heated on the inside, the product dries on the outside of the drum surface. The short exposure to a high temperature reduces the risk of damage to the product. The water or solvent evaporates and leaves the process at the top. If necessary, the vapour can also be sucked off locally around the drum. The dried product film finally reaches the knife and is scraped off.
In a double drum dryer the product is fed into the sump between the two main drums (which always rotate in opposite directions). The small gap between the drums can be set accurately to obtain a desired film layer.
Safe hands, total supervision
For the easy, hygienic drying of everything from baby / infant food to toxic chemicals, ANDRITZ Gouda is with you every step of the process. Product treatment before and after drying receives our equal attention. From kitchen preparation through to mill sifting and pneumatic transport, ANDRITZ Gouda offers you practical solutions as well as access to a wealth of informed research.
Realizing the future vision
Our technology is developing further and further: our third generation of drum dryers has been realized.
- A 100% closed system, also for vacuum operation;
- A system with minimum energy consumption and dust emission (a complicated filter system is unnecessary);
- Macvhines that are designed in accordance with the highest hygienic standards, thereby giving a guarantee of optimal hygienic during the complete production process. ANDRITZ Gouda's engineering and process departments are familiar with HACCP and EHEDG.
Our quality insurance consists of certification by ASME, TÜV, European PED CE and other local certificates no matter where in the world.
The well-thought-out construction of the knife holder guarantees an even pressure over the total length of the drum. The use of specific materials prevents vibrations as a result of scraping and guarantees uniform product removal. The pressure of the knife can be controlled simply and this is done outside the process area.
Separate process area
In the design, a clear distinction is made between the process section of the dryer and the mechanical parts. This, for instance, prevents the risk of contamination by lubricants (or contamination of the lubricants due to leakage of the product). It also improves the accessibility of parts for adjustment, inspection and maintenance.